Idler Main Bracket Adjustable Spacer .700" OAL TFX DMPE 200-025-99-1377
This spacer is used to load the bottom side of the idler main bracket to the gear drive cover. When assembling the idler bracket, this spacer is screwed into the bracket completely then the bracket is tightened at all of the surrounding studs. Then, using an Allen key you turn this clockwise until its face seats on the face of the gear drive. Next, use the bolt and washer supplied in the mounting kit (per block type) and tighten it up. Note: you will remove the stud in this hole if one has been used previously. This bracket adds the last bit of foundational support to the idler main bracket.