Product Description
Idler Jack Screw Block Kit 3.750"
Kit Contains:
1) 200-025-99-1362 Idler Bracket Jack Screw Block 3.75" Front Thin
1) 200-025-99-1363 Idler Bracket Jack Screw Block 3.75" Rear Thick
1) 200-025-99-117 Idler Jack Screw Kit
Jack blocks are used to mechanically tighten the belt rather than using a pry bar, by hand or piece of wood to get proper belt tension. There are 3 different lengths of jack blocks offered. We do this to suit the many combinations of belt lengths, idler pulley diameter, belt type, overdrive, etc. Many choose to buy all three lengths or simply install the idler assembly, take a measurement, and then order the correct length blocks.
The way these work is you leave the large idler nut just loose enough to slide and then tighten the belt with the two 3/8" stainless bolts a little at a time on each side to ensure the belt is square and straight. Tighten this way until you are happy with the belt tension and then tighten the large idler nut. Now here is where guys do different things. Some remove the jack blocks and some leave them loaded and tighten the lock nuts. I personally leave them in and use them as a secondary means of belt support. Both ways are acceptable.
